FAQ - MAJOR

Click "Q" to read the answer.

I have a type of product which comes with multiple model names. Will I have to file conformity verification report per each model name?

You can file a single conformity verification report covering multiple model names. Also you can file them in a series with name such as ABC XXX (where XXX is arbitrary number)

How can I manage conformity verification (method of measurement) for an ITE connected with non-ITE equipment (indicated in the figure) and administer conformity verification reporting?

Please carry out conformity verification test on a typical configuration/combination of equipment (see 6.1.3 EUT Configuration of Normative Annex 1 Technical Requirements) and submit the report on the subjected EUT.

My DTE is equipped with a battery to secure the operation of a part of functions at the time of power outage. Can I do without measurement of disturbance from the DTE at the time of power outage?

Please do the measurement under the condition including the power outage instance that causes maximum disturbance.

Is it alright if I file a single conformity verification report for the configuration like the one below?

Perform a conformity verification test for the total system and use the result for every portion subject to market. So you can attach the VCCI mark to all of the three equipment

Suppose I developed product C by combining product A and product B, conformity to VCCI of both of which were verified. Will I need conformity verification report on product C?

	Motherboard (common)	Daughter boards
Product A	(common)	Type a x 4	filed
Product B	(common)	Type b x 4	filed
Product C	(common)	Type a x 2, Type b x 2	new

As long as product C has a new type name you need to file conformity verification report for product C.

I have a commercialized printer product for which conformity verification report was filed to VCCI. This printer has both parallel port and Ethernet port built in. We are going to market the same printer with the Ethernet connector concealed under a new model name. Will I need to file a separate conformity verification report?

You can add a new type name to the filed verification report. Either that or you can newly file the product.